The build volume determines the maximum print size possible on your machine, while the origin offset determines the location of the X=0, Y=0, Z=0 position. If your prints are not centered, then there are 2 settings you should check within Simplif圓D – build volume and origin offsets. Please refer to the Sailfish configuration page for instructions on how to property restore these offsets. NOTE: If you recently installed the Sailfish firmware on your printer, this issue is most likely due to incorrect homing offsets.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |